OMNITEL, INC.
T2400-PC3
|
Modem Type |
Data (Asynchronous/Synchronous) |
|
Maximum Data Rate |
2400 bps |
|
Maximum Fax Rate |
N/A |
|
Data Bus |
8-bit ISA |
|
Fax Class |
N/A |
|
Data Modulation Protocols |
Bell 103A & 212A ITU-T V.22 & V.22 bis & V.21 |
|
Fax Modulation Protocols |
N/A |
|
Error Correction/Compression |
Unidentified |
|
CONNECTIONS | |||
|
Purpose |
Location |
Purpose |
Location |
|
Line in |
CN1 |
Line out |
CN2 |
|
COM PORT CONFIGURATIONS | ||
|
COM |
SW1/1 |
SW1/2 |
|
í COM1 |
On |
On |
|
COM2 |
On |
Off |
|
COM3 |
Off |
On |
|
COM4 |
Off |
Off |
|
DATA TERMINAL READY - DTR | |
|
Setting |
SW1/3 |
|
í Disabled |
Off |
|
Enabled |
On |
|
CARRIER DETECT - CD | |
|
Setting |
SW1/4 |
|
í Disabled |
Off |
|
Enabled |
On |
|
FACTORY CONFIGURED SETTINGS | |
|
Switch | Setting |
|
SW1/5 |
Off |
|
SW1/6 |
Off |
|
CLEAR TO SEND OPTIONS | |
|
Setting | J3 |
|
CTS follows RTS |
Pins 1 & 2 closed |
|
CTS follows CD |
Pins 2 & 3 closed |
|
&R- COMMUNICATIONS OPTIONS | |
|
Note: |
The &T1R Loopback connection established in answer mode. |
|
Command |
Protocol |
|
í &T1R |
Establish loopback connection in answer mode. |
|
Note: If you do not want to be in answer mode leave off the R on the end of the command. | |
|
PROPRIETARY COMMAND SET | |||
|
Type: |
Configuration | ||
|
Format: |
ATS(register)=(Command Value) | ||
|
Example: |
ATS18=0&T8 | ||
|
Description: |
Writes to or reads from a specified register. | ||
|
Register |
Command Value |
Function | |
|
S18 |
0&T8 |
Connects modem in originate mode, 0 set manual termination. | |
|
S18 |
30&T8 |
Connects modem in originate mode, 30 set timed termination to 30 seconds. | |
|
Note: If you want answer mode add an R to the end of the command. | |||
