Device Type	Recordable CD
Interface	SCSI-1
Spin Rate - Read	4x
Spin Rate - Write	2x
Formats Supported	Unidentified
View	Top

CONNECTIONS
Function	Label	Function	Label
Audio out - right channel	CN1	Chassis ground	CN3
Audio out - left channel	CN2

DIAGNOSTIC LED(S) - NOT DIAGRAMMED
LED	Color	Status	Condition
Speed - front panel	Green	On	4x and 2x spin rate
Speed - front panel	Yellow	On	1x spin rate
Speed - front panel	N/A	Off	No disc inserted
Busy - front panel	Green	On	Reading data from disc
Busy - front panel	Yellow	On	Writing data or audio to disc
Busy - front panel	Yellow	Blinking	Playing audio
Busy - front panel	N/A	Off	Idle or no disc inserted

MISCELLANEOUS TECHNICAL NOTES

SCSI ID selection: SW1 is for SCSI ID selection, 0 through 7. Default setting is 2. To select SCSI ID, turn off the power, press the top button to increase value and the bottom button to decrease value. The new SCSI ID will be registered when the power is turned on then off again. Termination: When terminating the drive, make sure the power is turned off, then plug a passive SCSI-1 terminator block to one of the SCSI-1 ports on the back panel. Host adapter for the RCD 5040 in a PC system is Adaptec AHA-1535.