TECMAR
WANGTEK 5150ES (33678-XXX VER.1)
|
Device Type |
Internal Tape Drive |
|
Interface |
SCSI |
|
Format |
QIC-120, QIC-150 (write) QIC-24, QIC-120, QIC-150 (read) |
|
Sustained Transfer Rate |
1800KBPS |
|
Size |
5.25 in. half height |
|
View |
Bottom |
|
USER CONFIGURABLE SETTINGS |
|||
|
Setting |
Label |
Position |
|
|
» |
Factory configured - do not alter |
JP3/A - C |
Unidentified |
|
|
Parity check enabled |
JP3/D |
Pins 1 & 2 closed |
|
|
Parity check disabled |
JP3/D |
Pins 1 & 2 open |
|
DRIVE SELECT ID |
|||
|
Drive ID |
JP1/Pins 1 & 2 |
JP1/Pins 3 & 4 |
JP1/Pins 5 & 6 |
|
0 |
Open |
Open |
Open |
|
1 |
Closed |
Open |
Open |
|
2 |
Open |
Closed |
Open |
|
3 |
Closed |
Closed |
Open |
|
4 |
Open |
Open |
Closed |
|
5 |
Closed |
Open |
Closed |
|
6 |
Open |
Closed |
Closed |
|
7 |
Unidentified |
Unidentified |
Unidentified |
|
TERMINATION POWER SELECTION |
||
|
Setting |
E1 |
|
|
» |
TERMPWR supplied by SCSI interface to drive |
Closed |
|
|
TERMPWR supplied by drive |
Open |
|
MANUFACTURERS RECOMMENDED MEDIA |
|
|
Tape |
Capacity |
|
DC 600A |
125 MB (in QIC-120 mode) |
|
DC 6150 |
150 MB (in QIC-150 mode) |
|
DC 6250 |
250 MB (in QIC-150 mode) |
|
DIAGNOSTIC LED(S) |
|||
|
LED |
Color |
Status |
Condition |
|
LED1 |
Amber |
Flashing |
Drive activity on the SCSI bus |
|
LED1 |
Amber |
Pulsing |
Drive fault condition exists |
|
LED1 |
Amber |
Off |
Drive not active |
|
Note: "Pulsing" LED1 refers to a flash 1-5 times every 3 seconds. |
|||
|
MISCELLANEOUS TECHNICAL NOTES |
|
Termination is enabled or disabled via a terminating resistor (see diagram). |
