NIC Type	Token-Ring
Transfer Rate	4/16Mbps
Data Bus	8/16-bit ISA
Topology	Ring
Wiring Type	Shielded twisted pair Unshielded twisted pair
Boot ROM	Available (Built-in Remote Program Load)

I/O BASE ADDRESS
Address		SW1/1	SW1/2
»	A00 - A0Fh	On	On
	A20 - A2Fh	Off	On
	A40 - A4Fh	On	Off
	A60 - A6Fh	Off	Off

INTERRUPT REQUEST
IRQ		SW1/3	SW1/4
	2/9	Off	On
»	3	On	On
	10	On	Off
	11	Off	Off
Note:If using the card in an 8-bit slot IRQ10 becomes IRQ3 and IRQ11 becomes IRQ2.

FLASH ROM ADDRESS
Address		SW1/5	SW1/6
	CC000 - CDFFFh	On	On
	D0000 - D1FFFh	Off	On
»	D8000 - D9FFFh	On	Off
	DC000 - DDFFFh	Off	Off

DMA CHANNEL
Channel		SW1/7	SW1/8
»	DMA0	On	On
	DMA5	Off	On
	DMA6	On	Off
	DMA7	Off	Off

NETWORK SEGMENT SPEED
Speed		SW2/2
»	16Mbps	On
	4Mbps	Off
Note:All cards on the network segment must have this option set the same.

CABLE TYPE
Type	SW2/3
Shielded twisted pair	On
Unshielded twisted pair	Off

FLASH ROM ENABLE
Setting		SW2/4
»	Enabled	Off
	Disabled	On
Note:The flash ROM stores the ROM boot programs, RPL (Remote Program Load) programs, LLC, and node address. If the flash ROM is disabled, the node address must be passed to the installed driver and the file RTR16LLC.COD must be present.

DMA BURST SPEED
Setting		SW2/6
»	Minimum	On
	Maximum	Off

CLOCK SOURCE
Setting		SW2/7
»	Onboard 8MHz clock	On
	I/O bus clock	Off
Note:If your system has an I/O bus speed greater than 8MHz you can improve system performance by selecting the I/O bus clock as the clock signal (SW2/7 Off) but the manufacturer warns that this setting will not work in all systems. If using the I/O bus clock setting, you should test the card thoroughly before attatching it to your network.

FACTORY CONFIGURED SETTINGS
Jumper	Setting
SW2/1	Off
SW2/5	On