NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	8-bit ISA
Topology	Linear bus
Wiring Type	Unshielded twisted pair
Boot ROM	Available

CABLE LENGTH
Legth		JP1
»	< 100 meters	Open
	> 100 meters	Closed
Note:The hub must also support cable lengths greater than 100 meters if the >100m option is used.

BOOT ROM
Setting		JP2A
»	Disabled	Open
	Enabled	Closed
Note:In earlier versions of this card there is no socket for a boot ROM. If you have one of these earlier socketless versions and you purchased it less than five years ago, you may return it to the manufacturer for an updated version. You can also solder in a socket for a boot ROM but you will void the warranty.

BOOT ROM ADDRESS
Address	JP2B	JP2C
C8000h	Closed	Closed
CC000h	Closed	Open
D8000h	Open	Closed
DC000h	Open	Open

I/O BASE ADDRESS
Address		JP2D	JP2E
	200h	Closed	Closed
	210h	Closed	Open
»	300h	Open	Closed
	310h	Open	Open

INTERRUPT REQUEST
IRQ		JP2F	JP2G	JP2H
	2	Closed	Open	Open
»	3	Open	Closed	Open
	5	Open	Open	Closed
	Programmed I/O	Open	Open	Open

TRANSMIT/RECEIVE WIRE POLARITY
Setting		SW1 (SW1/1 & SW1/2)
»	Normal	On
	Reversed	Off
Note:If the transmit/receive wires are reversed, they can be corrected for by setting this option to reversed. On some earlier versions of this card there are two switches, SW1/1 & SW1/2. On these older cards each switch should be set the same.

FACTORY CONFIGURED SETTINGS
Jumper	Setting
JP4	Unused

DIAGNOSTIC LED(S)
LED1	Hub LED	Condition
On	On	Network connection is good
Off	Off	Tx/Rx polarity crossover at adapter
Note:The Hub LED is located on the Hub not the NIC. If a crossover condition exists this can be corrected for by using switch SW1.