NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	16-bit ISA
Topology	Linear bus
Wiring Type	RG58A/U 50ohm coaxial AUI transceiver via DB-15 port
Boot ROM	Available

CABLE TYPE
Type		JP1A - JP1F
»	RG58A/U 50ohm coaxial	Closed
	AUI transceiver via DB-15 port	Open

I/O BASE ADDRESS & BOOT ROM ADDRESS
I/OAddress	Boot ROM Address	JP4A	JP4B
300h	C8000h	Closed	Closed
320h	CC000h	Open	Closed
340h	D0000h	Closed	Open
360h	D4000h	Open	Open

BOOT ROM
Setting		JP4C
»	Disabled	Open
	Enabled	Closed

INTERRUPT REQUEST
IRQ		JP5A	JP5B	JP5C	JP5D
»	2/9	Closed	Open	Open	Open
	3	Open	Closed	Open	Open
	4	Open	Open	Closed	Open
	5	Open	Open	Open	Closed

ONBOARD TERMINATOR
Setting		JP6
»	Disabled	Open
	Enabled	Closed
Note:If the card is on either end of the network segment the onboard terminator can be used instead of using an external terminator (JP6 closed).

COMPATIBILITY MODE
Setting		W16
»	Disabled	Closed
	Enabled	Open
Note:If the system in which the card is to be installed uses a C & T CS8220 chipset compatibility mode must be enabled (W16 open).

FACTORY CONFIGURED SETTINGS
Jumper	Setting
JP2	Unused

DIAGNOSTIC LED(S)
Color	Status	Condition
Green	On	Data is being transmitted or received
Green	Off	Data is not being transmitted or received
Red	Off	Network connection is good
Red	On	Network connection is broken
Note:The location of the diagnostic LEDs may vary on different revisions of this card.