NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	NuBus
Topology	Linear Bus
Wiring Type	Unshielded twisted pair
Boot ROM	Not Available

CABLE TYPE

Cable type is automatically determined by the card. If both the RJ45 and AUI ports are used, the card will default to RJ45.

FACTORY CONFIGURED SETTINGS
Jumper	Setting
SW1/Switch 1	Off

SIGNAL QUALITY
Setting		SW1/Switch 2
	Signal quality test enabled	Off
»	Signal quality test diabled	On

LINK INTEGRITY
Function		SW1/Switch 3
»	Link intergity enabled	Off
	Link integrity disabled	On
Note: If card is used in a pre-10BaseT cabling network, disable the link integrity function.

REVERSED POLARITY CORRECTION
Setting		SW1/Switch 4
»	Reverse polarity correction enabled	Off
	Reverse polarity correction disabled	On

DIAGNOSTIC LED(S)
L1	Condition
On	10BaseT link integrity exists
Off	10BaseT link integrity broken