Data bus:	16-bit, ISA
Size:	Half-length, full-height card
Hard drive supported:	Four IDE (AT) Interface drives
Floppy drives supported:	Two 360KB, 720KB, 1.2MB, 1.44MB, or 2.88MB drives

CONNECTIONS
Function	Location
34-pin data cable connector - floppy drive	J1
40-pin control cable - IDE interface 1	J2
40-pin control cable - IDE interface 2	J3
4-pin connector - drive active LED	JP3

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	DC-200M is sole controller	JP1	pins 3 & 4 closed
	DC-200M is secondary controller with interrupt IRQ12	JP1	pins 1 & 2 closed
	DC-200M is secondary controller with interrupt IRQ15	JP1	pins 5 & 6 closed
»	Floppy drive interface enabled	JP2	closed
	Floppy drive interface disabled	JP2	open

DRAM CONFIGURATION
Size	Bank 0	Bank 1
512KB	(1) 512K x 9	NONE
1MB	(1) 512K x 9	(2) 256K x 9
2.5MB	(1) 512K x 9	(2) 1M x 9
8.5MB	(1) 512K x 9	(2) 4M x 9

MISCELLANEOUS TECHNICAL NOTE

Note: Cache mode must disabled while installing operating systems other than DOS.