MAXTOR CORPORATION
AT ADAPTER BOARD
|
|
Data bus: 16-bit, ISA
Size: Half-length, full height card
Hard drives supported: Two IDE (AT) Interface drives
Floppy drives supported: None
|
CONNECTIONS | |
|
Function |
Location |
|
40-pin AT Interface (IDE) connector-internal |
CN1 |
|
2-pin connector-drive active LED |
CN2 |
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Location |
Setting | |
| » |
Hard drive port address is 1F0-1F7h |
JP1/Jumper 1 |
open |
|
Hard drive port address is 170-177h |
JP1/Jumper 1 |
closed | |
| » |
I/O Channel Ready enabled |
JP1/Jumper 2 |
closed |
|
I/O Channel Ready disabled |
JP1/Jumper 2 |
open | |
| » |
Factory configured - do not alter |
JP1/Jumper 3 |
open |
| » |
Factory configured - do not alter |
JP1/Jumper 4 |
closed |
| » |
Factory configured - do not alter |
JP1/Jumper 5 |
open |
| » |
Drive active LED enabled |
JP1/Jumper 6 |
closed |
|
Drive active LED disabled |
JP1/Jumper 6 |
open | |
