KOUWELL ELECTRONICS CORPORATION
KW-602B
|
Data Bus |
32-bit PCI |
|
Card Size |
Full-height, Half-length card |
|
Hard Drives supported |
Four IDE (AT) drives |
|
Floppy drives supported |
None |
|
Interface |
IDE, ATAPI, ATA-2 |
|
CONNECTIONS | |||
|
Function |
Label |
Function |
Label |
|
40-pin connector - primary IDE |
J1 |
10-pin connector - paddle card |
W1 |
|
2-pin connector - drive active LED |
J2 |
10-pin connector - controller |
PCW1 |
|
40-pin connector - secondary IDE |
J3 |
|
|
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Label |
Position | |
| » |
Disk change enabled |
W2/1 |
Closed |
|
Disk change disabled |
W2/1 |
Open | |
| » |
Factory configured - do not alter |
W2/3 |
Open |
|
PCI INTERRUPT SELECTION FOR PRIMARY IDE | |||||
|
Setting |
W3/1 |
W3/2 |
W3/3 |
W3/4 | |
| » |
INTA |
Open |
Open |
Open |
Closed |
|
INTB |
Open |
Open |
Closed |
Open | |
|
INTC |
Open |
Closed |
Open |
Open | |
|
INTD |
Closed |
Open |
Open |
Open | |
|
Disabled |
Open |
Open |
Open |
Open | |
|
PCI INTERRUPT SELECTION FOR SECONDARY IDE | |||||
|
Setting |
W4/1 |
W4/2 |
W4/3 |
W4/4 | |
|
INTA |
Open |
Open |
Open |
Closed | |
| » |
INTB |
Open |
Open |
Closed |
Open |
|
INTC |
Open |
Closed |
Open |
Open | |
|
INTD |
Closed |
Open |
Open |
Open | |
|
Disabled |
Open |
Open |
Open |
Open | |
|
LEGACY / NATIVE MODE CONFIGURATION | |||||||
|
Primary IDE |
Secondary IDE |
W3 |
W4 |
W5 |
W6 |
W7 |
W2/2 |
|
Legacy mode |
Legacy mode |
Enabled |
Enabled |
Open |
2 & 3 |
2 & 3 |
Closed |
|
Legacy mode |
Native mode |
Enabled |
Disabled |
Closed |
2 & 3 |
Open |
Open |
|
Native mode |
Legacy mode |
Disabled |
Enabled |
Closed |
Open |
2 & 3 |
Open |
|
Native mode |
Native mode |
Disabled |
Disabled |
Closed |
Open |
Open |
Open |
|
Note: Designated pins should be in the closed position. W6/pins 1 & 2 and W7/pins 1 & 2 are reserved. Note: Primary and secondary IDE drives are enabled by selecting a PCI interrupt or attaching the paddle card. Primary or secondary IDE drives are disabled by detaching the paddle card and disabling the PCI interrupt. To attach the paddle card, insert it into an ISA slot and connect PCW1 to W1. The paddle card is used to transfer IRQ14 and IRQ15 signals to the PCI bus on older mainboards that do not have this capability. | |||||||
|
MISCELLANEOUS TECHNICAL NOTES |
|
Your mainboard and BIOS determine operating modes. If your mainboard and BIOS support plug-and-play, the controller can operate in PCI native mode. If not, the controller operates in legacy mode. |
