KIMPSION INTERNATIONAL
WA6-V
Data bus: 16-bit, ISA
Size: Full-length, half-height card
Hard drives supported: Two MFM ST506/412 drives
Floppy drives supported: Two 360KB, 720KB, 1.2MB, or 1.44MB
Sector interleave: 1:1
Maximum heads/cyl.: 16 heads and 2048 cylinders
|
CONNECTIONS | |
|
Function |
Location |
|
4-pin connector-drive active LED |
CN1 |
|
20-pin data cable connector-drive 1 |
CN2 |
|
20-pin data cable connector-drive 0 |
CN3 |
|
34-pin control cable connector-hard drive |
CN4 |
|
34-pin data cable connector-floppy drive |
CN7 |
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Location |
Setting | |
| » |
Hard drive port address is 1F0-1F7h |
JP5 |
pins 2 & 3 closed |
|
Hard drive port address is 170-177h |
JP5 |
pins 1 & 2 closed | |
| » |
Floppy drive port address is 3F0-3F7h |
JP6 |
pins 2 & 3 closed |
|
Floppy drive port address is 370-377h |
JP6 |
pins 1 & 3 closed | |
| » |
Bracket ground option not used |
JP8 |
open |
|
Connects bracket to board ground |
JP8 |
closed | |
| » |
Pre-compensation set at 125ns. |
JP9 |
open |
|
Pre-compensation set at 187ns. |
JP9 |
closed | |
| » |
Single-speed floppy drive supported |
JP10 |
open |
|
Dual-speed floppy drive supported |
JP10 |
closed | |
|
MISCELLANEOUS TECHNICAL NOTES |
|
Notes: Do not combine single- and dual-speed floppy drives on the same controller card. There is no on-board BIOS format program. You must use software to low-level your drives. This controller is compatible with the Western Digital WD1006V-MM2. |
