Card Type	Hard drive controller card
Hard Drives supported	Two IDE (AT) drives
Floppy drives supported	Two 360KB, 720KB, 1.2MB, or 1.44MB drives
Data Bus	32-bit VESA Local Bus
Card Size	Full-length, full-height card

CONNECTIONS
Function	Location	Function	Location
25-pin parallel port - external	CN1	10-pin serial port (1)	JP1
34-pin cable connector - floppy drive	J1	10-pin serial port (2)	JP4
40-pin connector IDE(AT) interface	J2

USER CONFIGURABLE SETTINGS
Function		Label	Position
»	Parallel port is uni-directional	JP2	Closed
	Parallel port is bi-directional	JP2	Open
»	Floppy drive interface enabled	JP3	Pins 19 & 20 closed
	Floppy drive interface disabled	JP3	Pins 20 & 21 closed

IDE SPEED SELECTION
Speed		JP6
	Speed 0 (slow)	Pins 1 & 2, 4 & 5 closed
»	Speed 1 (fast)	Pins 2 & 3, 4 & 5 closed
	Speed 2 (turbo)	Pins 2 & 3, 5 & 6 closed

PARALLEL PORT ADDRESS SELECTION
Setting		JP3
»	LPT1 (378h)	Pins 13 & 14, 17 & 18 closed
	LPT2 (278h)	Pins 14 & 15, 16 & 17 closed
	LPT3 (3BCh)	Pins 13 & 14, 16 & 17 closed
	Disabled	Pins 14 & 15, 17 & 18 closed

SERIAL PORT 1 ADDRESS SELECTION
Setting		JP3
»	COM1 (3F8h)	Pins 1 & 2, 5 & 6 closed
	COM3 (3E8h)	Pins 2 & 3, 4 & 5 closed
	Disabled	Pins 2 & 3, 5 & 6 closed

SERIAL PORT 2 ADDRESS SELECTION
Setting		JP3
»	COM2 (2F8h)	Pins 7 & 8, 11 & 12 closed
	COM4 (2E8h)	Pins 8 & 9, 10 & 11 closed
	Disabled	Pins 8 & 9, 11 & 12 closed

BIOS ADDRESS SELECTION
Setting	JP5/Pins 5 & 10
Enable	Closed
Disable	Open

PARALLEL PORT INTERRUPT SELECTION
IRQ	JP3
IRQ7	Pins 22 & 23 closed
IRQ5	Pins 23 & 24 closed