Data bus:	16-bit ISA
Size:	Half-length, full-height card
Hard drive supported:	Two IDE(AT) drives
Floppy drives supported:	Two 360KB, 720KB, 1.2MB, 1.44MB, or 2.88MB drives

CONNECTIONS
Function	Location
4-pin connector - drive active LED	J1
40-pin primary IDE(AT) connector	J2
34-pin cable connector - floppy drive	J3
Optional drive power connector	J4

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Floppy drive interface enabled	JP6	Open
	Floppy drive interface disabled	JP6	Closed
»	IDE(AT) interface enabled	JP7	Open
	IDE(AT) interface disabled	JP7	Closed
»	Single speed floppy drives supported	JP8	Open
	Dual speed floppy drives supported	JP8	Closed
»	Floppy drive precompensation is 125 ns	JP9	Open
	Floppy drive precompensation is 187 ns	JP9	Closed
»	IOCHRDY signal disabled	JP10	Open
	IOCHRDY signal enabled	JP10	Closed

USER CONFIGURABLE SETTINGS (CONTINUED)
Function		Location	Setting
»	On-board BIOS ROM enabled	JP11	Open
	On-board BIOS ROM disabled	JP11	Closed
»	Primary floppy is any type other than 2.88 MB	JP14	Open
	Primary floppy is 2.88 MB drive	JP14	Closed
»	Secondary floppy is any type other than 2.88 MB	JP15	Open
	Secondary floppy is 2.88 MB drive	JP15	Closed

INTERRUPT TIMING SELECTION
Timing		JP1	JP2
»	Normal	Closed	Open
	Delayed until ACTIVE-signal is removed	Open	Closed

BIOS ADDRESS SELECTION
Address		JP12	JP13
»	C8000-CBFFFh	Open	Open
	CC000-CFFFFh	Open	Closed
	D8000-DBFFFh	Closed	Open
	DC000-DFFFFh	Closed	Closed