Data bus:	16-bit ISA
Size:	Three-quarter length, Full-height card
Hard drive supported:	Two IDE(AT) interface drives
Floppy drives supported:	360KB, 720KB, 1.2MB, 1.44MB

CONNECTIONS
Function	Location
34-pin control cable connector - floppy drive	J1
20-pin data cable connector - drive 1	J3
20-pin data cable connector - drive 0	J4
34-pin control cable connector - hard drive	J5
4-pin connector - drive active LED	J6

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Controller is incompatible with WD1003-WA2	W2	open
	Controller is compatible with WD1003-WA2	W2	closed
»	Hard drives in latched mode	W3	open
	Hard drives in non-latched mode	W3	closed
»	Caching enabled	W4	open
	Caching disabled	W4	closed

USER CONFIGURABLE SETTINGS(CONTINUED)
Function		Location	Setting
»	4-byte ECC enabled	W5	open
	7-byte ECC enabled	W5	closed
»	Hard drive primary address select	W6	open
	Hard drive alternate address select	W6	closed
»	Floppy drive interface primary address select	W7	open
	Floppy drive interface alternate address select	W7	closed
»	Factory configured - do not alter	W8	N/A
»	Single speed floppy drive supported	W17	open
	Dual speed floppy drive supported	W17	closed
»	Mounting bracket not grounded	W18	open
	Mounting bracket grounded	W18	closed