PURE DATA, LTD.

PDI8023-16T

NIC Type

Ethernet

Transfer Rate

10Mbps

Data Bus

16-bit ISA

Topology

Star

Wiring Type

Unshielded twisted pair

Boot ROM

Available

SOFTWARE CONFIGURATION RESET

Setting

E1

»

Normal operation

Pins 2 & 3 closed

 

Reset

Pins 1 & 2 closed

Note:Many of the options are configured using the setup utility provided with the card. To reset those configurations to the factory defaults, move E1 to the Reset position (pins 1 & 2 closed) and apply power for a few seconds. Always make sure that you turn off the power to the computer before you change any jumpers.


CARD I/D NUMBER

Number

E2A

E2B

E2C

E2D

»

1

Open

Open

Open

Closed

 

2

Open

Open

Closed

Open

 

3

Open

Closed

Open

Open

 

4

Closed

Open

Open

Open

Note:Up to four cards can be installed into a system at the same time. If more than one card is installed each one must have a seperate card I/D number.

LINK INTEGRITY TEST

Setting

E3

»

Enabled

Pins 1 & 2 closed

 

Disabled

Pins 2 & 3 closed

FACTORY CONFIGURED SETTINGS

Jumper

Setting

E5A

Open

E5B

Open

E5C

Closed

DIAGNOSTIC LED(S)

LED

Color

Status

Condition

LED1

Red

On

Card is being accessed by host computer

LED1

Red

Off

Card is not being accessed by host computer

LED2

Green

On

Data is being transmitted or received

LED2

Green

Off

Data is not being transmitted or received

LED3

Red

On

Receive wires are reversed and corrected for

LED3

Red

Off

Normal operation

LED4

Green

On

Network connection is good

LED4

Green

Off

Network connection is broken

Note:If LED3 is lit the receive wires are reversed. The card will automatically correct for this but the wires should be repaired as soon as possible.

Hosted by uCoz