7 1 0 0 - 2 1 MICROSCIENCE
NO MORE PRODUCED Native| Translation
------+-----+-----+-----
Form 3.5"/HH Cylinders 1077| 960| |
Capacity form/unform 121/ MB Heads 5| 7| |
Seek time / track 18.0/ ms Sector/track 44| 35| |
Controller IDE / AT Precompensation
Cache/Buffer KB Landing Zone
Data transfer rate 1.250 MB/S int Bytes/Sector 512
MB/S ext
Recording method RLL 2/7 operating | non-operating
-------------+--------------
Supply voltage 5/12 V Temperature *C |
Power: sleep W Humidity % |
standby W Altitude km |
idle W Shock g |
seek W Rotation RPM 3600
read/write W Acoustic dBA
spin-up W ECC Bit
MTBF h 36000
Warranty Month
Lift/Lock/Park YES Certificates
**********************************************************************
L A Y O U T
**********************************************************************
MICROSC. 7070-20/7100-00/-20/-21/7200-00 PRODUCT DESCRIPTION
+---------------------------------------------------------+
| +----+J4|XX
| 1----8 |XX Power
| |1
| |
| |1
| |XX I
| |XX N
| |XX T
| |XX E
| |XX R
| |XX F
| |XX A
| |XX C
| |XX E
| |XX
+---------------------------------------------------------+
**********************************************************************
J U M P E R S
**********************************************************************
MICROSC. 7070-20/7100-00/20/21/7200-00 PRODUCT DESCRIPTION
Jumper Setting
==============
J4 Master/Slave Select
----------------------
Pins 1-2 OPEN Single drive only
Pins 7-8 OPEN
Pins 1-2 CLOSED Master drive in a two drive system
Pins 7-8 OPEN
Pins 1-2 OPEN Slave drive in a two drive system
Pins 7-8 CLOSED
The other pins are not used!
**********************************************************************
I N S T A L L
**********************************************************************
MICROSC. 7XXX/8XXX SERIES JUMPER SETTINGS 280095-004, REV. A
Installation Procedure
----------------------
1. Installation precautions
---------------------------
Four (4) 6-32UNC screws, with 3/16" (4.78mm) maximum screw length,
are required for installation. Use caution when installing the
mounting screws to ensure no contact is made with drive's printed
circuit board.
2. In the CMOS (System BIOS) setup, select drive type as follows
----------------------------------------------------------------
Select a hard drive type that is equal to or less than the formatted
capacity of the drive.
NOTE
Drive parameters cannot exceed the specified capacity.
- Use user defined type or manually enter the drive parameters.
3. Disk partion options
-----------------------
Use DOS "FDISK" to create the partition table.
Utility software such as Disk Manager or Speedstor may be used.
4. High Level Format Options
----------------------------
If DOS "FDISK" is used to create the partitions, then use DOS
"FORMAT" to do the high level format.
If Disk Manager is used to create the partitions, then use Disk
Manager to do the high level format.
If Speedstor is used to create partitions, then use Speedstor to do
the high level format.
Always low-level formatted at the factory!
